Skip to content
Installation orientation guide for Condor's S5x/M5x Swap Engine Mount Set - E30

Installation orientation guide for Condor's S5x/M5x Swap Engine Mount Set - E30

We've redesigned our solid 24 valve swap UHMW engine mounts. The angle hasn't changed, but we have changed the stud locations. They'll work with the M50, S50, M52, S52, M54, and S54. Take a look at the illustration below for the proper installation orientation. The driver's side mount has two studs while the passenger's side has a through bolt.

Our swap mounts incorporate the correct angle and feature the correct stud location for a hassle-free install. The studs go through the round hole in the e30 subframe and the pins go through the slotted hole, just like an OEM engine mount.

You'll want to torque the nuts to 8-10 ft. lbs when installing.

These engine mounts are perfect for the track or street, and will dramatically change the way your swapped e30 drives. Make sure to add a set of our transmission mounts - they'll work with any transmission that you decide to use for your swap.  

You can pick up a set here: S5x/M5x Swap Engine Mount Set - E30

 

Previous article How to measure the hex on an E46 control arm.
Next article Installation guide for Condor E36 door cards.

Comments

Cole Barry - January 26, 2021

just to confirm because the forums say alot, these are to be used with e36 engine arms?

Leave a comment

Comments must be approved before appearing

* Required fields